Installation instructions for the TT-13B Tiger Tail Inner fender

READ BEFORE WORKING !!! at least once.

• Remove rear cowling assembly.
• Remove battery – ECU – Tool kit and Tank lift arm from plastic inner fender
• Remove bolt securing starter relay bracket.
• Remove tip over sensor from rubber mount grommet (you have to re-install this sensor relay in the same position)
• Remove all electrical harness ty-wraps and securing plastic clamps. (remember where everything went…see# 14)
• Remove lower sub frame attachment bolts from frame
• Loosen upper sub frame attachment bolts from frame (do not remove)
• Remove foot peg bracket bolts from sub frame on both sides (let exhaust hang)
• Remove 4 shoulder headed bolts from plastic inner fender and remove.

Now you should look like this.

• Insert your new Tiger Tail inner fender as shown.  It’s kind of a Houdini insert and twist.

• Now attach the inner fender to the sub frame as shown with the 2 front shouldered mount bolts.

•   Tweak the tail plate so that it installs under the rear sub frame mounting brace as shown.

•   You may now attach your TST-13B License plate bracket at this time (if you purchased one) as shown.

•   You should now make sure your electrical harness is configured correctly and going to the right places.  Don’t forget your tip over sensor (proper side up)

•   Re-install all mount bolts to the sub frame including exhaust hanger/foot peg brackets.

•   Re-install rear cowling, battery, ecu and hump release cable.

You should be about done.!